About how to import Tinybit library and programming

www.yahboom.com

How to import Yahboom Tiny:bit Micropython library and programming

1. You need to connect BBC micro:bit board to your computer. You will see a letter

drive, as shown below:

2. You need to send “tinybit_micropython.hex” we provided to micro:bit board. As

shown below:

Enter the micropython editor and click 【REPL】 in the menu bar. If the prompt

"MicroPython for Tinybit Modified by Yahboom Team" appears in the lower left

corner of the interface, as shown below. It proves that you have successfully

imported our library file.

PAGE 1
How to import Yahboom Tiny:bit Micropython library and programming 1. You need to connect BBC micro:bit board to your computer. You will see a letter drive, as shown below: 2. You need to send “tinybit_micropython.hex” we provided to micro:bit board. As shown below: Enter the micropython editor and click 【REPL】 in the menu bar. If the prompt "MicroPython for Tinybit Modified by Yahboom Team" appears in the lower left corner of the interface, as shown below.
PAGE 2
3. Next, you can start programming with Micropython, as shown below: 4. You need to close【REPL】 before clicking 【Flash】 to download the program. !Note: If you downloaded other programs on your BBC micro: bit board, except tiny:bit micropython program. Before you next use Micropython to program Building:bit, you need to send “tinybit_micropython.hex” to BBC micro:bit again. www.yahboom.
PAGE 3
If you always use the same BBC micro: bit for Building:bit Micropython programming, you didn't need to send the “tinybit_micropython.hex” file to the micro: bit multiple times. www.yahboom.