Instructions / Assembly

11
An ASSA ABLOY Group brand
P/N AYRT-210-INST-FUL Rev E
NOTE: For correct lever handing, the
hex set screw for the exterior
lever shank must be installed
as shown (Fig. 16).
A. Once correct handing is determined, remove the
clip that has held the hub in its correct position by
spreading clip ends to extract clip from shank as
shown in Figure 15.
Do not rotate cam from its original position.
("Top" is marked RED)
11. Remove clip from exterior escutcheon shank.
12. Install hex set screw.
Install the Exterior Lever
Hex Set
Screw
RH/RHR
LH/LHR
Figure 16
CW
A. Place set screw in hole on side of
shank toward latch (Fig. 16); turn set
screw clockwise (CW) to allow placement
of lever handle over shank.
Do not overtighten.
Figure 15
13. Install cylinder in exterior lever.
A. Install cylinder in exterior lever handle as
shown in Figure 17.
B. Insert key in cylinder.
Figure 17
Tailpiece
While supporting cylinder tailpiece (with finger)
rotate key 90° clockwise (CW) to vertical position
regardless of lever handing.
See Figure 18.
90°
Figure 18
(If necessary, remove key from cylinder)