Instructions / Assembly

12
An ASSA ABLOY Group brand
P/N AYRT-220-INST-FUL Rev E
Figure 19
90°
Figure 20
C. Ensure that cylinder key remains in previously
set vertical position (Fig. 19).
CCW
14. Place exterior lever handle over shank
until hole on handle aligns with set screw
in shank.
NOTE: Hex set screw should be
inserted enough for
lever handle to slide over
shank, clearing set screw.
Hex Lever
Set Screw
17. Rotate thumbturn counter-clockwise to horizontal position (Fig. 21).
Figure 21
16. Turn key 90° CCW to horizontal position regardless
of lever handing.
Pull to remove key (Fig. 20) and test operation of lever,
ensuring that latch moves smoothly.
If key cannot be removed, adjust the exterior lever set
screw
A. Remove hex key.
IMPORTANT: Test the lock's mechanical operation. Lift up and push down on lever
handle to retract the latch, ensuring that latch moves smoothly.
If operation is not smooth for these procedures, review the previous steps to ensure
proper installation, while maintaining proper alignment of escutcheons.
15. Secure lever handle by inserting hex key (Fig. 20)
and rotating set screw counter-clockwise (CCW).
This will retract the set screw back into the
lever handle to secure it.
Do not overtighten.