Instructions / Assembly

An ASSA ABLOY Group brand

P/N AYRT-220-INST-FUL Rev E

21. Insert four (4) AA alkaline batteries; the lock

will ﬂash, beep several times and respond with

voice prompt:

"Welcome to Yale Real Living".

22. Install battery cover and tighten Phillips

head screw.

IMPORTANT: Before installing the batteries, test the lock's mechanical operation. Place

the thumbturn in the horizontal position. Lift up and push down on both the interior and

exterior levers (one at a time) to verify that the latch is retracted by both levers in the un-

locked position.

Next place thumbturn in the vertical position. Lifting up or pushing down on the exterior

lever should not retract the latch. Lifting up and pushing down on the interior lever should

still retract the latch in the locked position .

Finally, insert key in cylinder and rotate clockwise until thumbturn moves to horizontal

(unlocked) position.

If operation is not smooth for any of these procedures, review the previous steps to ensure

proper installation, while maintaining proper alignment of escutcheons.

Install Batteries

Figure 22

Figure 24

Figure 23

CCW

Install the Interior Lever

NOTE: Hex set screw should be inserted

enough for lever handle to slide over

shank, clearing set screw.

18. Install hex set screw.

A. Place set screw in hole on side of

shank toward latch (Fig. 22); turn set

screw CW to allow for placement of lever

handle over shank.

Do not overtighten.

A. Remove hex key.

19. Place interior lever handle over shank

until hole on handle aligns with set screw

in shank.

20. Secure lever handle by inserting hex key and

rotating set screw CCW (Fig. 23).

This will retract the set screw back into the

lever handle to secure it in place.

Do not overtighten.

NOTE: Thumbturn should still be in horizontal position.