Instructions / Assembly

An ASSA ABLOY Group brand

P/N AYRT-220-INST-FUL Rev E

INSTALL LOCK

Preparation

A. Remove the latch (Fig. A) and strike plate from the packaging.

If required, pull to extend to 2-3/4" backset position.

NOTE: Different holes are used for (2) through bolt posts depending on backset (Fig. A).

Figure A

2-3/8" through bolt posts

2-3/4" through bolt posts

Before installing the lock on the door:

NOTE: The latch can be installed in only one of two ways - with the bevel (slope) of the

latch facing out or facing in while standing outside of the door.

NOTE:

Both latch face and strike plate have adhesive-backed covers to prevent marring and

should be removed upon installation.

IMPORTANT: Latch bevel must match door bevel

and plunger of deadlocking latch must stop on

strike when door is closed.

Make sure door has been prepped according to speciﬁcations in template

included with lock.

If the door opens in, the bevel will face the exterior (regular); if

the door opens out, the bevel will face the interior (reverse).

Strike plate

Plunger

NOTE: Latch ships with backset in 2-3/8" position (Fig. A).

Backset is the measurement from door edge to center of 2-1/8" diameter hole

(see template supplied with lock).