Specifications

10
Adding accessories to an existing system
To provide additional protection you can add extra door/window contacts, PIRs, keyfob
remote controls, keypad remote controls, help buttons and smoke detectors. These are
available separately from your local stockist.
Keyfob
1 Press the Arm and Home buttons together and
continuously for 5 seconds until the LED stops
ashing, to switch off the tamper while installing
the new device.
(The siren will beep in response.)
2 Press the Home and Emergency buttons together
and continuously for 5 seconds until the LED stops
ashing to enter learn mode.
(The siren will beep and flash in response.)
3 Press device learn/test buttons (see Chapter 3) to
trigger learning-in signals.
(The siren will beep and flash when each device is learnt in.)
4 When all the devices have been learnt-in press and
hold the Disarm button to quit learn mode.
5 Press the Arm and Emergency buttons together
and continuously for 5 seconds until the LED stops
ashing to rearm tamper protection.
Adding devices to an already installed
system
The installed system will be controlled by either a
keyfob(s) or a keypad(s).
Keypad
1 Enter Setting mode: Press Panic button A
followed by the pincode
(Indicated by a continuously flashing LED.)
2 Switch OFF system tamper: Press Panic button
A followed by 2
(The siren will beep in response.)
3 Enter learn mode: Press Panic button A followed
by 4 . (The siren will beep and flash in response.)
4 LEARNING: Press device learn/test buttons (see
Chapter 3) to trigger learning-in signals.
(The siren will beep and flash when each device is learnt in.)
5 Exit learn mode: When all the devices have been
learnt in, press Panic button A and 5 to quit learn
mode.
6 Switch ON system tamper: Press Panic button A
and 3 to rearm tamper protection.
7 Exit Setting mode: Press Disarm twice to exit.
(The keypad LED will now stop flashing.)