Specifications

opening after test/learn button has been

pressed

• Batteries are completely exhausted. Change

batteries with new alkaline replacements

• The magnet is too far away from the door contact.

Check that the gap between door contact and

magnet is not greater than 10mm.

Siren reset procedure

• Switch the power switch to Off position. Press

the learn buttons a few times to drain any residual

power.

• Switch DipSwitch 1 to On position

• Switch the power switch to On position. Wait 5

seconds. Siren LED will ash 1 cycle.

• Switch DipSwitch 1 to Off position

The siren is now reset and all learnt devices are

cleared from memory. See chapter 3 for initial set-

up. Please be reminded that all devices will need

to be learnt in at this point. One by one, press the

learnt button on device to learnt in.

Keypad reset procedure

The keypad is tamper protected. Please ensure the

siren tamper is disabled before you open the keypad

cover. See Page 9, table 1 for siren tamper disable

procedure.

• Open cover and remove battery. Reinsert with

the number “3” key pressed (taking care 3 is held

down).

• The keypad will go back to the “0000” keypad

code.

• The keypad will now have to be re-learnt into the

Siren, see chapter 3.