Specifications

3
Unpack all the parts on a table top
The easiest way to get to know the system and get it up and running quickly is to get all the
devices and accessories programmed on a table top before locating and mounting them.
2
Siren
1 Remove the cover by unscrewing the single screw
located on the lid.
2 Ensure the dip switches position
are as shown in the diagram.
If the switches are in the
wrong position, please change
accordingly.
DO NOT SWITCH THE POWER SWITCH TO ON
POSITION AT THIS STAGE.
PIR movement detectors
1 Pull out the plastic pull tab on the back of the PIR.
This will activate the batteries.
(A red light can be seen flashing through the lens. This will last
for 30 seconds indicating the component’s initiation. )
ale
Y
Status
LED
Learn/Test
Button
Cover
screw
NORMAL
Door/window contacts
1 Pull out the plastic pull tab found on the side of the
main unit. This will activate the battery.
ale
Y
Learn/Test
button
LED
Gap no more
than 10mm
Magnet
Sensor
Dip Switches
DSW 1: Siren Reset
DSW 2: Jamming detection
DSW 3: Not in use
DSW 4: Siren as Master/Slave (On position only)
i
ale
Y
1
2
3
6
5
4
7
8
9
0
Panic button A
Panic button B
Disarm
Home
Arm
LED
Learn button=
Press 8 and 9 together
/
Keypad remote control
1 Pull out the plastic battery saver tab at the back of
the remote keypad. This will activate the batteries.
(Button not in
use)