Specifications

5
Programming the Siren-based system
(without control panel)
3
The siren is the heart of the system. All components must be recognised by the siren.
This unit is equipped with the latest type of
radio receiver using FM radio technology. If the
system is armed any criminal attempt to interfere
detector transmissions will trigger an alarm.
If the alarm is frequently triggered by interference
there may be high levels of unusual radio signals
in your area. Some kinds of electronic equipment
can generate this kind of radio interference.
In the unlikely event of you experiencing problems
with interference, it is recommended that you
switch interference detection off.
i
SETTING
Enable/disable Jamming & interference
detection:
• Set Dip switch 2 for interference detection. Switch
On to enable and Off to disable (recommended
default).
The system is now ready for wall mounting.
2
3
WARNING
The siren is very loud, be prepared! Take care not
to activate the siren tamper switch unnecessarily.
Switch the siren’s power switch to ON
(The LEDs will now flash with one short beep.)
Once powered, the siren will enter learn
mode for 3 hours. All tamper protections
are disabled within this time period. Please
ensure that ALL devices are fitted before
this mode expires.
1
The system is pre-learnt in the factory and the
system should recognised all the items (within
this kit) as default.
If the items are not recognised, deleted by
accident or purchased accessories, please press
learnt/action buttons on the accessories (when
the power switch is first turned on and under
learn mode) to learn each one into the system.
Do not press the siren learn button. See Chapter
2 for learn button location. The siren will beep
each time it receives a learnt signal.
i