Specifications

6
Mounting alarm devices
4
Before mounting the keypad and siren ensure that the siren tamper is
disabled.
Mounting the siren
Ensure the tamper switch is fully depressed when
the siren is mounted. If there is a gap, pack with a
suitable spacing material.
Round
Siren
Base
Wall
Spring Guide
Spring compressed
firmly against wall
1 Using the large screws and wall plugs provided,
mount on the desired wall through the 4 mounting
holes. If there is a gap between the wall and the
tamper switch mechanism pack with a suitable
spacing material.
2 Fix the siren cover with the securing screw.
Mounting other devices
Find a location where the device is to be mounted,
see section “Location Planning” for suggestions.
Mounting the Keypad:
1 Knock out the fixing holes. Drill holes into the wall
using the fixing holes as a template.
2 Fit wall plugs into the wall and fix back cover with
the screws provided. Fix front of the keypad onto
the back plate.
Battery Saver tab
Wall Fixing
knockouts x2
Mounting the PIR
1 Open the PIR by via the bottom screw. Knock out
the relevant holes at the base. The center two
knockout holes are for at wall mounting while the
4 side holes are for corner mounting.
Wall fixing
knockouts x2
Corner fixing
knockouts x4
Battery tab
2 Drill holes into the wall using the knockout holes on
the base as a template. Secure the base with the
screws provided.
3 Fit the PIR back together and tighten bottom
screw.
Before proceeding to mount the devices
physically, it is useful to check that it is not out of
radio range by doing a simple range test. Please
ensure the system tamper is disabled.
• Keypad: Hold the keypad in the desired
location and press the arm button.
(The siren will beep as confirmation.)
• Help button: Hold the device in the
desired location and press the emergency
button for 2 seconds.
(The siren should respond with a single beep.)
• All other devices: Hold the device in the
desired location and press the learn/test
button.
(The siren should respond with a single beep.)
When you are satisfied that the devices work
in your chosen locations, proceed with the
installation as described in the next page.
If the siren does not respond, the location may be
out of range, try alternative locations until reliable
radio contact is obtained.
i