Specifications

9
Using the help button
Activate: Press and hold panic button for 3
seconds, the LED will light briey and the siren will
be activated.
Silence: Press and hold panic button for 10
seconds, the LED will light briey and the siren will
be silenced.
Using the smoke detector
The smoke detector will indicate a fire by sounding
its built-in siren, lighting the LED and activating the
external siren and strobe.
-Smoke detection
When smoke is detected the device will activate for
a minimum of 10 seconds with a two tone alarm and
ashing LED for a local re alarm. The detector will
also activate the external siren and strobe.
• Pressing the test button when in an alarm
condition will silence the alarm for 10 minutes, it
will automatically resume smoke detection again
after this period.
• If the smoke density is still over the alarm
threshold, then the smoke detector will remain in
an alarm condition and it will repeat the local fire
alarm and activate the external siren and strobe
again.
-Testing
Smoke detector testing should be done on a regular
monthly basis. Pressing the test button will make
the LED ash, the audible sounder chime and will
send a radio test signal to the siren when the button
is released. If nothing happens after pressing the
test button then change the batteries.
-Recalibration
The smoke detector might need recalibrating after
time to ensure it is working at its optimum. This is
done by pressing and holding in the test button until
the LED ashes and it beeps after 10 seconds. The
detector will then start its self-calibration routine.
Keypad Modes:
Table 1
KeyFob Modes:
Table 2
Please note that silencing the alarm with the
help button does not disarm the system. If the
alarm is armed prior to activation, the system
will re-arm after being silenced with the help
button.
i
• Sending learn signal
Press any key except the emergency button.
• Siren tamper (Enable)
Press and hold down Arm and emergency for 5
seconds.
• Siren tamper (Disable)
Press and hold down Arm and Home for 5
seconds.
• Learn mode (Enter)
Press and hold down Home and emergency for 5
seconds.
• Learn mode (Exit)
Press and hold down disarm for 5 seconds.
Entering setting mode:
Press Panic button A followed by pincode (factory
default is 0000). You can now select different function.
(The LED on the keypad will start flahsing)
Function setting:
Press Panic button A , followed by one of the
following number key:
1 Send learning/testing signal (same as 8+9)
2 Disable Siren tamper
3 Enable Siren tamper
4 Enter learn mode (not suitable for first time set-up)
5 Exit learn mode
7 Keypad to work with control panel based sysem.
8 Keypad to work with siren based system.
Exiting setting mode:
Press disarm twice.
(The LED will now stop flashing. If not, press disarm twice
again)
Panic alarm using keypad
Activate: Press and hold Panic button A & Panic
button B together.
Silence: Press disarm follows by pincode.
Panic alarm using keyfob
Activate: Press and hold Panic button.
Silence: Press disarm.