Installation Sheet

ManualsBrandsYale ManualsHardwareSeabrook Passage Door Lever Set with Round Rose from the Edge Series

P/N - Rev AYE TLKINSTL

Yale Edge Series

Tubular Lockset, Knob

Installation Instructions

For use on doors 1-3/8" to 1-3/4" (35mm - 45mm)

Backset is distance from door edge to center of hole on door face.

Select Proper Backset

Backset

2-3/8" or 2-3/4"

(60mm - 70mm)

To adjust backset from 2-3/8" to 2-3/4"

To adjust backset from 2-3/4" to 2-3/8"

Push latch tail.

Pull latch tail.

Template

NOTE:

TEMPLATE MUST

BE PLACED ON

HIGH EDGE OF

DOOR BEVEL

MARK

DRILL

2-1/8" (54mm)

HOLE

FOLD HERE

1-3/4" (45mm)

THICK DOOR

1-3/8" (35mm)

THICK DOOR

MARK

PROPER

DOOR

THICKNESS

DRILL 1" (25mm)

HOLE IN EDGE OF DOOR

2" (51mm) DEEP

CAUTION:

If printed from

website print 1:1

scale. Measure

dimensions for

accuracy before use.

2-3/8" (60mm) BACKSET

2-3/4" (70mm) BACKSET

2-3/4" (70mm)

2-3/8" (60mm)

Latch Tail

Summary of content (4 pages)

PAGE 1
Yale Edge Series Tubular Lockset, Knob Installation Instructions ® Select Proper Backset For use on doors 1-3/8" to 1-3/4" (35mm - 45mm) Backset is distance from door edge to center of hole on door face. Latch Tail Backset 2-3/8" or 2-3/4" (60mm - 70mm) To adjust backset from 2-3/8" to 2-3/4" Pull latch tail. 2-3/8" (60mm) To adjust backset from 2-3/4" to 2-3/8" Push latch tail.
PAGE 2
1 Mark Door Fold and apply template to high edge of door bevel and mark center of door edge as indicated on template at desired height from floor; approximately 36" (914mm). Mark center hole on door face through guide on template for either 2-3/8" (60mm) or 2-3/4" (70mm) backset. 2 Drill Holes Drill 2-1/8" (54mm) hole through door face as marked for lockset. Note: Drill holes from both sides to prevent splitting. Drill 1" (25mm) hole in center of door edge through to 2-1/8" (54mm) hole for latch.
PAGE 3
Install Latch Insert latch in hole keeping it parallel to face of door. Mark outline and remove latch. Chisel 1/8" (3.2mm) deep or until latch face is flush with door edge. Insert latch in hole keeping it parallel to face of door. Mark two (2) fastener holes, remove latch and drill pilot holes with 1/16" (1.6mm) drill bit. Using provided screws, install latch. Note: For drive-in latch, drill hole size indicated on template and press latch until it is flush with door edge.
PAGE 4
5 Install Exterior Knob Insert knob with spindle into latch. Make certain that stems are positioned correctly though latch holes. Spindle Latch Hole Press flush against door. Stems 6 Install Interior Knob Install interior knob and rose by placing on spindle and aligning screw holes with stems. Stems Screw Holes Plush flush against door. Insert screws through holes and tighten. Spindle To Change Hand of Lock Retainer Key hole must be at bottom position.