Installation Sheet

P/N - Rev AYE TLKINSTL
2
Mark Door
1
Fold and apply template to high edge of door bevel
and mark center of door edge as indicated on
template at desired height from floor; approximately
36" (914mm).
Mark center hole on door face through guide on
template for either 2-3/8" (60mm) or 2-3/4" (70mm)
backset.
Drill Holes
2
Drill 2-1/8" (54mm) hole through door face as
marked for lockset.
Note: Drill holes from both sides to prevent splitting.
Drill 1" (25mm) hole in center of door edge through
to 2-1/8" (54mm) hole for latch. Check template for
correct size for your latch application.