Installation Manual

32
P/N - - - Rev AYRL EMICL PBINSTL FUL
Resetting Lock to Factory Default
Factory Setting
Registration
required*
Disabled
Disabled (Off)
Enabled
Disabled
5 Times
60 Seconds
Settings
Master CodePIN
Automatic Re-lock
Inside Indicator Light
One Touch Locking
Audio Mode
Wrong Code Entry Limit
Shutdown Time
Disabled
Privacy Button Setting
DisabledLockout Mode
Reset Button
Access
Interior Lock
(4" Shown)
Factory Settings
When resetting the lock, all user codes,
including the Master code*, are deleted. AllPIN
programming features are reset to original
default settings (see below).
1. Remove the battery cover and batteries.
2. Remove the interior lock to access the reset
button hole. (See image at right.)
3. Re-insert 3 batteries and insert a small
screwdriver into the hole; holding the reset
button for 3 seconds.
4. While still holding the reset button, insert the
4th battery and hold the reset button for an
additional 3 seconds.
5. Release the reset button.
6. Re-install the interior lock onto the door.
Upon reset, Master Code creation is thePIN
only option available and must be performed
prior to any other programming of the lock.
*The Master code must be registered prior to any otherPIN
programming of the lock.
For best results, the lock should be installed on the
door when resetting the lock to factory default. If the
process was done and the lock was not installed on
the door, review the Re-Handing instructions listed in
Hardware Troubleshooting.