Installation Manual

34
P/N - - - Rev FYRL EMICL TSINSTL FUL
Feature Programming Through Menu Mode
Using Master code*PIN
Continue
Complete
Continue
Complete
3
U
U
Privacy Button Setting
Enable
Disable
Handing the Lock
Preforms automatic
handing of the lock
Volume Setting
Language Setting Mode
Lockout Mode
**Network Module Setting
Join the Network
Enable
Disable
Exit the Network
English
Spanish
French
Silent
Low
High
1. Touch screen with back of hand or palm to activate.
2. Enter 4-8 digit master code* followed by key.PIN
Lock Response: " Menu mode, enter number, press key to continue."
3. Enter digit corresponding to the function to be performed followed by the key. Follow the voice commands.
*The Master code must be registered prior to any other programming of the lock.PIN
Note: After Master code is entered, lock will automatically hand itself. For best results, lock should be installedPIN
on door during this process. If this process was done and lock was not installed on door, review the Re-Handing
instructions listed in Hardware Troubleshooting.
Master Code SettingPIN
M
User Codes
Enter
Delete
Advanced Lock Settings
1~25: without network module or with iM1 network module
1~250: with Z-Wave Plus or ZigBee network module
**This function appears only with
network module installed.
Automatic Re-lock
Disable
30 sec
Inside Indicator Light
One Touch Locking
Enable
Disable
Enable
Disable
M
1
2
Continue
Complete
60 sec
3 min
2 min
***This function appears only with
P/N C620 installed.
***Set-up Digital Keys
1~12: with Bluetooth