Troubleshooting Guide

P/N YRD540WV Rev 5
Auto Lock: After a successful code entry or
manual unlock with the thumbturn, the lock will
automatically re-lock in an effort to keep your
home secure. This feature is optional, and can
be turned off. In the ON mode, the lock will
automatically re-lock after thirty (30) seconds.
Back Button: While in Menu Mode, pressing this
icon cancels the current operation and returns
the user to the previous step.
Inside Indicator Light: Located on the inside of
lock. Shows active status (Locked) of lock.
Language: Choosing English (1), Spanish (2) or
French (3) becomes the (default) setting for the
lock's voice prompts.
Lock Calibration: Calibration ensures the
correct side of the door is secured and locked
properly when the door is closed. Lock
calibration is done when the lock is initially
installed or when the lock is reset.
Definitions
Low Battery: When battery power is low, the Low
Battery Warning indicator flashes RED. If battery
power is completely lost, use the 9 volt battery
override. To use the 9V battery override apply 9V
battery, in either direction, to terminals below the
touchscreen for backup power option. Wake up the
lock and enter your passcode to unlock the door.
Master Passcode: The Master Passcode is used for
programming and for feature settings. It must be
created prior to programming the lock. The Master
Passcode will also operate (unlock/lock) the lock.
One Touch Locking: When the latch is retracted,
activating the keypad will extend the latch (during
Auto Lock duration or when Auto Lock is disabled).
When One Touch Locking is not in use (disabled),
any valid passcode will re-lock the lock.
Privacy Mode: The Privacy feature disables the
keypad so the lock cannot be unlocked from the
outside. Turn on privacy mode with the app or by
pressing the button on the inside of the lock.
Shutdown Time: The unit will shut down
(flashing RED) for sixty (60) seconds and not
allow operation after the wrong passcode entry
limit (5 attempts) has been met.
Tamper Alert: Audible alarm sounds if
attempting to forcibly remove outside lock from
door.
User Passcode: The User Passcode operates the
lock. Maximum number of User Passcodes is 25.
Volume: The volume setting for passcode
verification is set to Low (2) by default;
otherwise it can be set to High (1) or Silent (3)
for quiet areas.
Wrong Passcode Entry Limit: After five (5)
unsuccessful attempts at entering a valid
passcode, the unit will shut down for sixty (60)
seconds and not allow operation.