User Manual

20 Introductory Recording Tutorial

02R Getting Started Guide

Setting the Input Level

Assuming that the 02R is powered ON and your music source is playing,

the very ﬁrst thing you need to do is set up a basic control room monitor

mix. When you recall Scene Memory 0 “0 Initial Data”, all the channel

faders are set to the 0 dB mark.

Setting Fader Levels

If the faders are not set to 0 dB, you should perform the following steps to

optimize the input signal level for the best performance:

1. Set the fader for MIC/LINE 1 to the 0 dB mark.

The 0 dB fader position is a good place to start when setting fader levels. It

is a good setting with regard to signal level and noise performance and it

leaves room for you to raise the level later, if necessary.

2. Set the STEREO fader to the 0 dB mark.

The stereo output meters are indicating the stereo output level. The stereo

mix signal is now being output to the digital and analog STEREO OUT

connectors.

Selecting a Monitor Source

Before you can hear anything through your monitor ampliﬁer and

speakers, you have to select a Control Room source:

1. Press the [ST] button of the CONTROL ROOM buttons group.

This selects the stereo bus for monitoring in the control room.

2. Adjust the volume with the C-R LEVEL control.

You should be able to hear the sound source through your monitor

speakers. If you are using stereo headphones, you will need to adjust the

PHONES LEVEL control to set a comfortable listening level.

Note: Be very careful with the level settings, especially if you are using stereo

headphones. When you are adjusting a unit as complex as the 02R, it is possible for

you to inadvertently switch on a very loud signal source. Damaged loudspeakers or

ampliﬁers can be very expensive. Damage to your hearing can be much worse. Your

ears are for life!

∞

STEREO

AUX 5

MONO

AUX 6

DIM

2TR-D3 ST

2TR-D2 2TR-A2

CONTROL ROOM

C-R

LEVEL

010