User Manual

UTILITY-MASTER
196 Chapter 8 UTILITY Mode • A5000/A4000                                                     
Knob 5
[ Turn] DIG&OPT Bit (Digital & Optical Output Bits)
Specifies 20-bit or 24-bit output for the digital coaxial and
optical outputs.
[Range] 20, 24
• Set this parameter to “20” when connecting to digital
equipment which does not support 24-bit audio data.
Knob 1
Same function as Cursor q (page 195).
Knob 3
[ Turn] Output
Selects the output for which a level offset will be specified
via the Level Offset parameter (Knob 5, below).
[Range] StereoOut, AsgnOutL&R,
AsgnOut1&2 — AsgnOut5&6, DIG&OPT (Ste-
reoOut, AsgnOutL&R, AsgnOut1&2 on the
A4000)
Knob 5
[ Turn] Level Offset
Specifies a level offset for the output selected via Knob 3
(Output, above). If set too high this parameter can result
in distorted sound, depending on the number of notes
being played simultaneously and the type of sound being
played.
[Range] -0dB — +24dB
• If the stereo output signal has been assigned to an
assignable output via the Stereo Out To Assignable
Out parameter, the stereo output offset value takes
priority.
Cursor w
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn
action
Cursor/Page — Output — Level Offset
Press
action
Tree View ————
w
Cursor