User Manual

                                                      A5000/A4000 • Chapter 9 COMMAND 213
About the COMMANDS
Knob 1
[ Turn] Cursor
Positions the cursor.
[ Press] EXEC
Press this knob to call the freeze confirmation display.
Press Knob 5 (YES) to actually execute the freeze opera-
tion.
Knob 3
[ Turn] Freeze Type
Sets the source of the settings to be applied to the sam-
ples.
[Range] EasyEdit → Sample,
SampleBank&LpMode → Samples,
SampleBank → Samples,
LpMode → Samples
• EasyEdit → Sample ... The Program mode Easy
Edit settings are applied directly to the related
samples (Sample Banks). The Easy Edit
parameters are initialized after execution, with
the exception of the following parameters:
MIDI Control (page 101) if the target is sam-
ples, or MIDI Control (page 101), Pitch Fine
(page 98), Key Range Shift (page 99), and
Key Low/High Limit (page 99) if the target is
Sample Banks. In some other cases some
parameters may not be applied to the samples
or Sample Banks. The samples within a target
Sample Bank are not affected.
• SampleBank&LpMode
→ Samples ... The Sam-
ple Bank settings are directly applied to the
samples it contains. The Sample Banks set-
tings are initialized after execution. At the
same time the Loop Mode (page 123) settings
of all samples within the specified Sample
Bank are changed.
• SampleBank
→ Samples ... The Sample Bank
settings are directly applied to the samples it
contains. The Sample Banks settings are ini-
tialized after execution.
• LpMode
→ Samples ... The Loop Mode (page
123) settings of all samples within the speci-
fied Sample Bank are changed.
Knob 5
[ Press] EXEC&CONT
Press this knob to call the freeze confirmation display.
Press Knob 5 (YES) to actually execute the freeze opera-
tion.
Knob 1
Same function as Cursor q (page 213).
Knob 2
[ Turn] From Program
Selects the source Program for the Freeze operation.
[Range] 001 — 128
Knob 3
[ Turn] To Type
Determines whether the Easy Edit settings will be applied
to all samples (Sample Bank), or to a single specified
sample (Sample Bank).
[Range] AllSamples, OneSample
• AllSamples ... All samples (Sample Banks) used
by the program will be affected.
• OneSample ... Only the specified single sample
(Sample Banks) will be affected.
Knob 5
[ Turn] To Sample
Specifies the target sample or sample bank for the
Freeze operation.
All samples (Sample Banks) assigned to the Program
selected via the From Program parameter can be
selected.
• This parameter can only be used when the To Type
parameter is set to OneSample.
[ Press] EXEC&CONT
Press this knob to call the freeze confirmation display.
Press Knob 5 (YES) to actually execute the freeze opera-
tion.
Cursor q
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn
action
Cursor — Freeze Type — —
Press
action
EXEC — — — EXEC&CONT
q
Cursor
Cursor w
(when the FreezeType is EasyEdit → Sample)
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn
action
Cursor
From
SampleBank
To Type — To Sample
Press
action
EXEC — — — EXEC&CONT
w
Cursor