User Manual

                                                      A5000/A4000 • Chapter 9 COMMAND 215
About the COMMANDS
Knob 2
[ Turn] Regist Type
Determines whether Program or Sample initial settings
are to be registered.
[Range] Program, Sample
Knob 5
[ Press] EXEC&CONT
Press this knob to call the register confirmation display.
Press Knob 5 (YES) to actually execute the register oper-
ation.
Knob 1
Same function as Cursor q (page 214).
Knob 2
[ Turn] Regist Source EFFECT
Specifies the source of the data to be registered as the
initial effect settings.
[Range] off, SourcePgm, FactorySet
• off ... No initial effect settings will be registered.
The currently registered settings are retained.
• SourcePgm ... The effect settings of the specified
Source Program will be registered.
• FactorySet ... The initial factory effect settings will
be registered.
Knob 3
[ Turn] Regist Source SETUP
Specifies the source of the data to be registered as the
initial setup settings.
[Range] off, SourcePgm, FactorySet
• off ... No initial setup settings will be registered.
The currently registered settings are retained.
• SourcePgm ... The setup settings of the specified
Source Program will be registered.
• FactorySet ... The initial factory setup settings will
be registered.
Knob 4
[ Turn] Regist Source CONTROL
Specifies the source of the data to be registered as the
initial control settings.
[Range] off, SourcePgm, FactorySet
• off ... No initial control settings will be registered.
The currently registered settings are retained.
• SourcePgm ... The control settings of the specified
Source Program will be registered.
• FactorySet ... The initial factory control settings
will be registered.
Knob 5
[ Turn] Source Program
Specifies the source program for the Register operation.
[Range] 001 — 128
• This setting has no effect if if the Regist Source
EFFECT, Regist Source SETUP, and Regist Source
CONTROL parameters are not set to SourcePgm.
[ Press] EXEC&CONT
Press this knob to call the register confirmation display.
Press Knob 5 (YES) to actually execute the register
operation.
Knob 1
Same function as Cursor q (page 214).
Knob 3
[ Turn] Regist Source
Specifies the source of the data to be registered as the
initial sample settings.
[Range] SourceSample, FactorySet
• SourceSample ... The setup settings of the speci-
fied Source Sample will be registered.
• FactorySet ... The initial factory setup settings will
be registered.
Cursor w (when the RegistType is Program)
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn
action
Cursor
Regist Source
EFFECT
Regist Source
SETUP
Regist Source
CONTROL
Source
Program
Press
action
EXEC — — — EXEC&CONT
w
Cursor
Cursor w (when the RegistType is Sample)
Knob 1 Knob 2 Knob 3 Knob 4 Knob 5
Turn
action
Cursor — Regist Source —
Source
Sample
Press
action
EXEC — — — EXEC&CONT
w
Cursor