User Manual

Installing Optional Equipment
                                                              A5000/A4000 • Appendix 241
4 . Turn the A5000/A4000 SCSI terminator switch “ON.”
• Set the CSCI terminator switch on the A5000/A4000 circuit board (“A” in the illustration, “TERM” on
the circuit board itself) to the “ON” position (the terminator is set to “ON” at the factory).
5 . Remove the four gold-colored screws holding the hard disk mount panel, and remove
the mount panel from the A5000/A4000.
6 . Attach the hard disk to the hard disk mount panel with the four hard disk installation
screws.
7 . Connect the SCSI cable (50-pin) and the power cable (long) to the hard disk unit.
• The connectors are “keyed” so that they cannot be inserted the wrong way around.
A
Terminator Switch
B
Hard disk mount panel
Hard disk installation screws
SCSI cable (50-pin)
Power cable (long)