User Manual

Installing Optional Equipment
248 Appendix • A5000/A4000                                                               
4 . Disconnect the two FDD cables (“FDD CN5” and power “CN5”) from the main circuit
board.
• The FDD flat cable is held in place by a cable strap. Remove the cable from the cable strap before instal-
lation.
5 . Remove the four gold-colored screws with which the FDD is attached, and slide the
FDD backward (toward the rear panel) to remove it.
6 . Turn the FDD unit over, and remove the mount panel from the drive by removing the four
gold-colored screws.
7 . Attach the ZIP drive to the mount panel using the screws removed in step 6.
• Do not use screws other than those removed in step 6. Other screws can damage the ZIP drive.
A
A
FDD unit
B
ZIP Drive
FDD Mount Panel
Tighten in the following order:
q → w → e