User Manual

Installing Optional Equipment
                                                              A5000/A4000 • Appendix 249
8 . Position the ZIP drive inside the A5000/A4000.
• Guide the ZIP drive into place using the groove on the side panel.
9 . Attach the ZIP drive using the same four screws removed when removing the FDD unit.
1 0 . Connect the IDE cable (40-pin) and the power cable (short) to the hard disk unit.
• Connect the longer end of the IDE cable from the central connector to the ZIP drive.
• The connectors are “keyed” so that they cannot be inserted the wrong way around.
1 1 . Connect the ZIP drive IDE cable (40-pin) to the connector on the A5000/A4000 circuit
board.
• Connect the other end of the flat cable from the ZIP drive (the flat, thin cable) to the corresponding con-
nector on the sampler’s main circuit board (marked “C” in the illustration below, “IDE CN4” on the cir-
cuit board itself). The connector is “keyed” so that it will only go in one way.
A
A
ZIP Drive
Tighten in the following order: q → w → e
C
ZIP Drive
IDE Cable
Power Cable (short)