User Manual

32
Chapter 4. Basic operation for input channels
This chapter explains basic operation for input channels/ST IN channels.
About input channels
Blocks used to control input channels
On the PM1D system, you can use 96 {48} monaural input channels and 8 {4} stereo ST IN channels. A signal patched to
one of these input channels passes through the internal four-band EQ/compressor/gate, and is sent to the STEREO bus
or MIX bus.
The following blocks on the CS1D console are used to control input channels.
• INPUT blocks 1–4
These blocks adjust the pan and level etc. of monau-
ral input channels 1–96 {1–48} and send them to the
STEREO bus or MIX bus. Each block contains 12
channels of modules.
• ST IN block
This block adjusts the pan and level etc. of the stereo
ST IN channels 1–8 {1–4} and send them to the STE-
REO bus or MIX bus.
• SELECTED INPUT CHANNEL block
This block controls most of the mix parameters for
the selected input channel or for the L or R channel
of a ST IN channel, such as head amp settings, EQ/
compressor/gate settings, and send to the STEREO
bus or MIX bus.
INPUT block 2
INPUT block 1 INPUT block 3
INPUT block 4
ST IN block
SELECTED INPUT CHANNEL block