User Manual

72 Chapter 6—Input Channels
DM1000—Owner’s Manual
Routing and EQ’ing Input Channels
1 Press the [SEL] button or move the fader for the channel you wish to control.
2To route each Input Channel, use the following buttons in the SELECTED
CHANNEL section:
• ROUTING [1]–[8] buttons ................These buttons route the currently-selected Input
Channel to a Bus.
• ROUTING [STEREO] button............When this button is turned on, Input Channel
signals are routed to the Stereo Bus.
• ROUTING [DIRECT] button............When this button is turned on, the cur-
rently-selected Input Channel is routed to its
Direct Out. (See page 111 for more information
on Direct Out.)
The corresponding button indicator lights up.
3To control EQ for the currently-selected channel, press one of the following
buttons to select the band you wish to adjust:
• EQUALIZER [HIGH] button ............HIGH band
• EQUALIZER [H-MID] button ..........HIGH-MID band
• EQUALIZER [L-MID] button ...........LOW-MID band
• EQUALIZER [LOW] button ..............LOW band
4 Use the EQUALIZER [Q], [FREQUENCY], and [GAIN] controls to adjust the Q,
frequency, and gain of the band selected in Step 3.
See page 65 for more information on EQ.
Tip:
•Pressing and holding down the button selected in Step 3 resets the corresponding band
parameter.
•Pressing the SELECTED CHANNEL [HIGH] and [LOW] buttons simultaneously resets all
band parameters for the current EQ.