User Manual
29
RECORDING COMPACT DISCS
9
5
Display information during programming
Selected disc
Side of the tape
Next playback order
Selected track
number
Total remaining time on
the side of the tape
Programmed track numbers light up
and unprogrammed ones flash.
To record programmed tracks from one or
more discs
1 Press the CD input selector button and load a disc (or
discs) on the disc table.
2 Follow steps 3–6 on page 27.
3 Press the PROG button.
* “PGM” and “P-01” will light up on the display, and all
track numbers on the selected disc will begin flashing.
4 If necessary, select a desired disc by pressing the DISC
SKIP button.
5 Select the desired track number by pressing the track
number input buttons.
6 Repeat steps 4 and 5 to program more selections for the
side A of the tape. You can select the same track again.
* Pressing the TIME button displays the total remaining
time on the side of the tape for about 1 second, and
then it is replaced by the display of the next playback
order.
* If “ERR” appears on the display, the track number just
selected cannot be programmed because there is not
enough time remaining on the side A of the tape.
However, at this time, if any other track number is
flashing continuously on the display, you can program
it instead of the unprogrammable one.
7 After you finish the programming for the side A, press the
TAPE button.
* “Pu” appears on the display, then you can begin
programming for side B.
8 Repeat steps 4 and 5 to program selections for the side B
of the tape. You can select the same track again.
* If “ERR” appears on the display, the track number just
selected cannot be programmed because there is not
enough time remaining on the side B of the tape.
However, at this time, if any other track number is
flashing continuously on the display, you can program
it instead of the unprogrammable one.
9 Press the EDIT button. (“EDIT” appears on the display.)
The recording is automatically started.
Notes on tape-editing
•
If programs are made selecting tracks from more than one
disc, during recording, the PLAYXCHANGE button on the
CD player is disabled.
•
To check, cancel or correct program data, refer to page
14.
•
The maximum number of tracks that can be programmed
is 20.
•
This function can be used to program up to track number
15.
-
+
12345
12345
678
67890
ABCDE
TIME
PROG
TAPE EDIT
+
I0
STOP
PLAY/PAUSE
DISC SKIP
RANDOM
TUNER
TAPE
PLAY STOP
REC/PAUSE
SLEEPPOWER VOLUME
DECK
CD
/
TUNER
A/B
MODE
OPEN/CLOSE
INPUT
USER
REPEAT
LOCATION
PLAY
MUSIC
FLAT
1
6
2
7
3
8
4
9
1211
5
10
TRACK
PGM
A
1
6
2
7
3
8
4
9
1211
5
10
TRACK
PGM
A
REMT
1
1
TIME
TIME
1
1
3
7
9
4