User Manual

4. Setting the monitor and meter sections

Set the PHONES SELECT switch to the "STEREO"

position.

Set the PHONES volume to around "7".

Make sure the METER SELECT switch is in the "4

TRK" position.

5. Adjusting the input level

Set the channels 1 and 2 input switches to the

MIC/LINE position.

Set the MASTER fader to "7".

Set the PAN controls for channels 1 and 2 between

the center and the extreme "L" position, as shown.

Push the input faders for channels 1 and 2 up to

"7".

Set the GAIN controls to the LINE position, start the

rhythm programmer and adjust its output level so

the "+3" segment on the track-1 level meter lights

only briefly on the signal peaks.

Pull the input faders back down to "0".

— The proper input levels for channels 1 and 2 are

now set. —