Thank you Tor purchasing the YAMAHA R-2000 AM TEM stereo )receiver. CONTENTS GONER'S MANUAL ~UJ IMPORTANT Pinsetter record The serial number of your Uit in thé space below. Mod -2000 Serial No.: The serial number is located on the rear of the cabinet. Retain this Rower's Manual in a safe place for suture reference, WARRING To prevent fire or shock hazard, do not expose this appliance to rain or moisture.
Re ac constructional the safety and persisting instructors should be read before the appliance is operated. 2 detain Instructional sanely and operating incrustations should be retained for suture reference. 3 Hectic Warnings—All warnings on the appliance and in the operating instructions should be answered to. 4 Follow Instructional aerating and other instructions shouts bie followed.
T Example of Antonia Grounding as per National Electrical Code Instructions st ab Ground b Leah-in Wire wie 2 Antenna To Discharge L Receiver Uit ] G Grand wire Ground Clamps it Suitable Grounding i Electrode Driven 8 into the Earn (244 Meters) a Use No. 10 AWG copper or No. B AWG aluminum or Na.
--2000 CONNECTING THE SPEAKERS The matching impedance of this amplifier is 8 ohms, One, two ar three pairs of speakers may be connected. If only one pair is connected the recommended speaker impedance may be anywhere between 4 and 16 ohs.
CONNECTING THE FM ANTENNA Chaos an FM antenna that is appropriate to the locate reception conditions., Consider the distance from the broadcast station and possible interfering abject such as surrounding tall buildings, In cases where there is & strong signal from a cola station. a portable T-type antenna is usually adequate. Connect the feeder wire to the 300 obm terminal, sirree the wire out tight, and tum o obtain optimum reception.
FRONT PANEL PARTS AND FUNCTIONS € POWER SWITCH This is a “push-on, push-off" type power switch. When power is furred on the red bar above the switch and the digital frequency cosplay will light 8 RX MODE 2.8 When the received FM station is weak or being interfered with, this indicator its to show that the R-2000 is in DX mode. LOCAL When the received FM station Is sufficiently strong, this indicator lights 1o denote local mods.
© BAND SELECT BUTTONS These swishes select ether FM or AM broadcasts. The AMIGA Indicator (@ ) next to the digital display shows the selected band. © PHONES JACKS Used far lagging in headphones. When you want 1o fiendish to headphones only, the Speaker switch should both be set {o the Cff position, © SPEAKER SWITCH With this switch, you can select speaker set A, set B, set G, or both sets And B.
@® MODE SWITCH Allows switching between stereo and mono operation, Normally the witch should be set for stereo @ FM MUTING SWITCH Turning this switch on (M) activates the muting sir cult and silences the noise that would otherwise be heard between FM stations, When the received station s very weak, it too will be silenced.
1 LISTENING TO AM BROADCASTS RECORDING TAPES PRESET TUNING W saw o . Press the Tuner button . Press the AM button. . Press either the Up or the Down.side of the Tuning button. The receiver will automatically scan the AM band in the selected direction.
2000 TROUBLESHOOTING Po war fs not applied . . ; Po war s n The power cord is not plugged in. Plug in the power cord Thar is no sound with any position of the input The Speakers switches aro ot set corrector. St hem correctly. selector. : The input cords are not connected securely. Pius thee in security ’ The speaker connections sre not secure. Secure the connections ° Thar is no sound from one speaker. The Balance control is set all the very to the left or right. | Adjust the balances control correctly.
13 —=2000 SPECIFICATIONS AUDIO SECTION Minimum RIS Output Power per Channel 8 sonny, 20 16 20,000 Hz, 0.015% THD 150 W (21.8 GBW) Input Hypersensitiveness Phone MM 2.5 mvi47 k-frosh, 100 pF or 220 pF 2.5 mV100 k-ohms, Chance Separation {1 kHz, vol ~30 dB, 5.1 k-ohms) Audiotape to Other Channel 4 9 & ohms, 1 kHz, 100 pF 0.01% THD 165 W 1222 dBW) Phone MG 160 #1100 oms e dE 8 ohms, 20 10 20,000 Mz, 0.
