RISK OF ELECTRIC SHOCK) Do Kot PEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER {OR BACK), NO USER-SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. ® Explanation of Graphical Symbols The lightning hash with arrowhead symbol, within an equilateral triangle, is intended to alert you to the presence of insulated “dangerous voltage’ within the product’s enclosure that [ ray be of sufficient magnitude To constitute 8 rig of electric shock to parsons.
OPE| The R-7 is 2 sophisticated stereo receiver, To ensure paper operating for the best possible performance, please read this manual carefully, 2 Chase the installation of your B-7 carefully, Avoid placing it In direct sunlight or roles 16 5 source of heat. Also avoid locations subject to vibration and excessive dust, hast, cold or moisture. Keep away from such sources of hum as transformers or motors.
R-7 Ba sure to connect the lat (L} and right {R) channels [r— ! consistently from component to component, i reception poor with the lop tense, | b _Sp AL run 8 5-10 meter insulated Speaker B R — wire outriders, T Y = Dir action of . | Connect the AM loop antenna f broadcasting i } provided {in the accessories ! station : envelope). ft may be detached trim its bracket if desired and . | placid at a distance from the set. | wan e Switched power can be tat vein-lsad.
R-7 ® REGULAR MODEL {rear pane) @ ABOUT THE REGENCY STEP SWITCH Ares other than the United States and Canada; because inter station frequency spacing is different in different areas, pleads set rear panel FREQUENCY STEP switch to agree with the station spacing in your ares {50 kHz FM/9 kHz AM or 100 kHz FM/10 kHz AM). #FREQUENCY STEP switch ® VOLTAGE SELECTOR The voltage selector switch on the rear pans of the R-7 frustum be set for your focal voltage BEFORE plugging in the AT mains supply.
Ouster covering diameter less than 6 mm: Coopers 7 —1 Tercentenary Opera, 1mn subclass avarice approx e Conn get in accordance with in the drawing below. {2) Insert the core wire thrash the hole, (1} {4} Outer covering diameter greater than 6 m: Confrere Lo e N Concerning oo g — Aurora S, {4} Tighten and Era lea &4 downward screwdriver | | o loosen, | fix in piece with a screwdriver.
= CONNECTING TURNTABLE Connect the output cord of the turntable 1o the receiver’s PHONON jacks with correct channel polarities, and connect the ground wire to the GND terminal, Normally, connecting the ground wire produces minimum hum, but in some cases better results ere obtained with the ground wire disconnected.
@ SIGNAL QUALITY INDICATOR Indicates the strength of the received signal. When making an antenna connection, adjust the antenna’s height and direction for maximum signal indication, £ PRESET STATION BUTTONS Up 10 16 station frequencies and reception modes {delectable between FM only, AM only, or FM and AM combined} can be programmed by using the preset station butting together with the 18 selector button Once the station is preset, it can be tuned in.
R-7 @ LOUDNESS CONTROL Compensates tor bur ears’ reduced sensitivity to the extreme high and (ow frequencies at low volumes. Se tit to the Flat position with the VOLUME control set to the loudest level at which you fasten. Then, when you want 1o fasten at lower volume levels, rotate the LOUDNESS control to the [eft instead of using the VOLUME control. This will retain the natural balance of the high and jow frequencies.
YAMAHA PROGESTIN & ON/OFF BUTTONS Used 1o worn the R-7 ON or OFF, B INPUT SELECTOR BUTTONS Used to select the program spurge 1o be listened to. @ SELECTOR BUTTON Elects the range of the preset station buttons, @ UP/DOWN BUTTONS Press ether button 1o scan the FM or AM band for station, € VOLUME UP/DOWN BUTTONS Press hither button to adjust the volume level, BATTERY INSTALLATION 121 Twa “AA, RB” type dry cel} batteries should be used.
AUTO TUNING Press the TUNER button, . Press the FM/AM selector to select AM or FM, Set the TUNING MODE button to AUTO. . Press either the UP or the DOWN side of the TUNING bitten for 2 or 3 seconds, The receiver will autocratically scan the AM or FM band in the selected direction, When a station is found, the scan will stop and the station will be locked in automatically. Use the TUNING button repeatedly to tune in your desired station. .
Before assuming that your receiver is fealty, cheek following the troubleshooting fist which details the corrective action you can take yourself without having to call a service engineer. |f you have any doubts or questions, get in touch with your ns sparest Yamaha sealer L o G Power is not applied even though the POWER switch is warned on, The power cord is pot pigged in ot Plug in the power cord, There is no sound even when the lout Detector button is pressed. “The speaker connections are not secure.
