User Manual

English
E-9
ADJUSTMENT BEFORE USING THE SUBWOOFER
1 Set the VOLUME control to minimum (0).
2 Turn on the power supply to all the
components.
3 Play a source and adjust the amplifier’s
volume control to the desired listening level.
4 Increase the volume gradually to adjust the
volume balance between the subwoofer and
the main speakers.
5 If necessary, you may set the HIGH CUT
switch to the HIGH position.
Before using the subwoofer, adjust the subwoofer to obtain the optimum volume and tone balance between the subwoofer and
the main speakers by following the procedures described below.
Notes
● Once the volume balance between the subwoofer and the
main speakers is adjusted, you can adjust the volume of
your whole sound system by using the amplifier’s volume
control.
However, if you change the main speakers to others, you
must make this adjustment again.
● For adjusting the VOLUME control and the HIGH CUT
switch, refer to “Frequency characteristics” on page 10.
Note about setting the HIGH CUT switch
This subwoofer is designed so that the optimum tone
balance between the subwoofer and the main speakers is
obtained when this switch is set to the LOW position. The
tone balance may change, however, depending on the room
size, the distance from the subwoofer to the main speakers,
and so on. If necessary, switch it to the HIGH position.
INPUT1
FROM AMPLIFIER
OUTPUT
TO SPEAKERS
INPUT2
/MONO
HIGH CUT
AUTO
STANDBY
STANDBY-RED
ON-GREEN
OFF
LOW
HIGH
OFF
POWER
ON
LOW
HIGH
2
VOLUME
0I0
OFF
POWER
ON
INPUT1
FROM AMPLIFIER
OUTPUT
TO SPEAKERS
INPUT2
/MONO
HIGH CUT
AUTO
STANDBY
STANDBY-RED
ON-GREEN
OFF
LOW
HIGH
LOW
HIGH
VOLUME
0I0
1, 4
5
Rear panel