User Manual

English
E-7
/MONO
HIGH CUT
LOW
HIGH
VOLUME
INPUT1
FROM AMPLIFIER
OUTPUT
TO SPEAKERS
INPUT2
AUTO
STANDBY
STANDBY-RED
ON-GREEN
OFF
LOW
HIGH
OFF
POWER
ON
0I0
INPUT1
FROM AMPLIFIER
OUTPUT
TO SPEAKERS
/MONO
HIGH CUT
LOW
HIGH
VOLUME
INPUT1
FROM AMPLIFIER
OUTPUT
TO SPEAKERS
INPUT2
AUTO
STANDBY
STANDBY-RED
ON-GREEN
OFF
LOW
HIGH
OFF
POWER
ON
0I0
INPUT1
FROM AMPLIFIER
OUTPUT
TO SPEAKERS
For connections, keep the speaker wires as short as
possible. (Cut the excessive wire if necessary.) If the
connections are faulty, no sound will be heard from the
speakers. Make sure that the + and – polarity markings of
the speaker wires are observed and set correctly. If these
wires are reversed, the sound will be unnatural and lack
bass.
How to Connect:
Red: positive (+)
Black: negative (–)
Caution
Do not let the bare speaker wires touch each other or
any metal part of the subwoofer. This could damage the
subwoofer, the amplifier or the speakers, or all of them.
1 Press and hold the terminal’s tab, as shown in the figure.
2 Insert the bare wire end properly into the terminal hole.
[Remove approx. 10 mm (3/8”) insulation from the
speaker cord.]
3 Release your finger from the tab to allow it to lock
securely on the cord’s wire end.
4 Test the firmness of the connection by pulling lightly on
the cord at the terminal.
m Using two subwoofers
Connect the speaker output terminals of the amplifier to the INPUT1 terminals of the subwoofer, and connect the OUTPUT
terminals of the subwoofer to the main speakers.
Left speaker
Right speaker
Subwoofer
Speaker output
terminals
To AC outlet
Connecting to the INPUT1/OUTPUT terminals of the subwoofer
Subwoofer
To AC outlet
Amplifier
➂
➀
➁