CONTENTS Cautions The Names and Functions of the Parts Assembly and Adjustments Connections to Your Amplifier or Receiver How to Play Records Changing Cartridge Stylus and Mains Frequency | Specifications and Accessories Trouble Shooting
Mo v [ CAUTIONS READ THIS BEFORE OPERATING YOUR GYP-271 The is & sensitive piece of precision audio equipment. This manual s requited reading I you ara 1o get the bast from it Be very careful not to drop or jar the UP-211, particularly after it has been fully assembled and sl adjustments made. 31 iris accidentally bumped, check carefully that nothing has gone out of adjustment, or readjust accordingly.
ASSEMBLY AND ADJUSTMENTS The acrylic dust cover has been made fully detachable, so that the UP-211 can be used at will with the dust cover off, 1t is wrapped separately in the original packing from the Yamaha factory, and should be attached in the first place s shown in the diagram, Align the studs on both hings with the grooves, and slip them first on {1} end then along {2}, Simply reverse this when you wish fo detach the dust caver, TICKTACKTOE: DUST COVER: After removal of the two transit sowers, and bef
First loop the drive belt around the fare drum shaped pulley on the underside of the turntable {the belt and drum are visible through the larger holes neat the rind. Grip the turntable by the finger holes reaper the center, and place the central hole directly over the central shaft, The instructions in the next section on ‘Fitting the Drive Brit’ should also be carried out at this time.
31 4 B} Nate the aiding of the colored leads attached to the head shell: one sterns pair being green/ sod, and the other whiteouts. Observe the maker's constructions carefully in attaching the metal sleeves to the cartridge connectors. A salt pair of tweezers will be invaluable. Note lase the position of the overhang setting mark on the head shell.
(1} Slowly rotate the balance counterweight in {2 the direction indicated until the tone mm is perfectly balanced, parallel with the motor board A very sl rotation only should be made at @ teems, until the headship floats freely, no finger needing to the supported. Return the tone arm 1o the arm rest once perfect balance hes hen achieved.
Eyed The grooved pole projecting backwards farm the top of the tong-arm bearing assembly acts as the inside force canceler. By hanging the lulls weight from the appropriate groove of the pole, the unbalanced force which the record groove wall experts on the tip of the stylus {causing it to ride up the outer wall, spoiling stereo balance, and even ‘skating” across the surface of the record in warmer cast san be perfectly canceled. This gives middies-of-the-groove tracking.
| E CONNECTIONS TO YOUR AMPLIFIER OR RECEIVER i L RAND HOW TO PLAY RECORDS {1 Plug the right and Jaf antenna loads (1} Set the input selector of your receiver of farm the back of the UP-211 {clearly identifiable to PONG, Hed with the ferrets L and R} into the lee {2} Put the record of your choice on the mute and bight-fand FOND input sockets of your table. I you nave chosen an extended-play amplifiers, etc, record with the large center hole, use the EP {2} The third lead is the GROUND lead, and hum adapter.
CHANGING CARTRIDGE STYLUS AND MAINS FREQUENCY The curing lever, located immediately above the PRAY & EJECT switch ar the right of the motor board, is convenient when raising and dowering the tone arm and cartridge for brief interruptions 1o the audition of & record.
