Owner's Manual

Quick Start Guide
9
EMX5 Owner’s Manual
Using the Built-in Effects
It is possible to add effects that simulate the sound of different performance
environments, such as concert halls and small clubs.
1. Use the [PROGRAM] rotary encoder to select the desired
effect.
q Turn the [PROGRAM] rotary encoder to select the program.
w The selected effect program number flashes in the display.
e Press the [PROGRAM] rotary encoder to confirm your selection.
2. Turn on ( ) the FX RTN [FX ON] switch.
The switch lights up to indicate that it is on. Connect a control device such as the optional FC5 foot
switch (sold separately) to the [FOOT SW] jack, which lets you conveniently bypass/enable the built-
in effects.
3. Set the FX RTN [LEVEL] control to the [ ] position.
4. Use the [AUX2/FX] send controls to adjust the effect depth for each channel
you wish to apply the effect.
5. Use the FX RTN [LEVEL] control to adjust the overall effect depth.
If you wish to change effect parameters such as reverb time or delay time, adjust the [PARAMETER]
control. (See section !8 on page 10.) For details about the parameters of each effect that can be
adjusted with the [PARAMETER] control, refer to the “Effect Programs” on page 17.
Display
NOTE
• For details about available effects, refer to the “Effect Programs” on page 17.
• If no operation is detected for an extended period of time, and the selected program is not confirmed,
the system will automatically return to the previously confirmed program.
t