Operation Manual

60 Chapter 5—Tutorial

01V96 Version 2—Owner’s Manual

Overdubbing to Other Tracks

This section describes how to overdub the musical instruments or microphone connected

to the INPUT connectors 1 and 2 to the digital MTR’s Tracks 9 and 10, while listening to the

performance recorded on Tracks 1–8.

Setting the Input Levels

1 Connect the musical instruments to INPUT

connectors 1 and 2, and adjust the corre-

sponding [PAD] switches and [GAIN] con-

trols so that the [PEAK] indicators

temporarily ﬂash at the highest volumes.

2 Press the LAYER [1–16] button.

Input Channel Layer 1–16 is now available for control from the channel strip section.

3 Press the DISPLAY ACCESS [HOME] button, then press the [F1] button to dis-

play the Meter | CH1-32 page.

4 Make sure that [ON] button indicators for the channels to which the instru-

ments or microphone are connected are lit, then raise the corresponding

faders to 0dB.

Turn off the [ON] buttons for the channels not in use.

5 While the musicians play the musical instruments, check the input channel

levels using the level meters on the display.

20dB

GAIN

-16

-60

PAD

PEAK

[PAD] switch

[GAIN] control

[PEAK] indicator