Owner`s manual

218 Chapter 18—Pro Tools Remote Layer

02R96 Version 2—Owner’s Manual

Panner Operation via the Joystick

1 Select the track you wish to pan.

2 Press the [GRAB] button, turning on the [GRAB] button indicator.

3 While the [GRAB] button indicator is lit, operate the Joystick.

If you move the Joystick for direct panning while the [GRAB] button indicator is lit, the pan

position is speciﬁed as an absolute value, which may cause the pan position to jump dras-

tically.

You can also restrict the trajectory direction of the Joystick. To limit movement to the L and

R directions, press and hold down the [DIRECT] button and move the Joystick. To limit

movement to the up and down (front and rear) directions, select 3 Knob mode in the Pro

To ols Panner window.

Panner Operation via Knob Controls

You can control the following parameters using the DYNAMICS controls.

1 Select the track and output, if desired.

2 Press the ROUTING [6] button to select the knob control mode that is appro-

priate for the parameter you wish to control.

3 Use the appropriate control to adjust the parameter.

Pressing and holding down the [Command] key on the keyboard and rotating the controls

reduces the change in the parameter values.

Controls ROUTING [6] indicator is off ROUTING [6] indicator is on

THRESHOLD Front position Front divergence

RANGE/RATIO Rear position Rear divergence

ATTACK F/R position F/R divergence

DECAY/RELEASE LFE level Center percentage

HOLD/GAIN Channel volume