Owner`s manual

54 Chapter 4—Analog I/O & the AD Input Section
02R96 Version 2—Owner’s Manual
AD Inserts (AD 1–16)
AD Inputs 1 through 16 feature switchable analog inserts on 1/4-inch TRS
phone jacks for the send and return signals. They are wired: sleeve–ground,
ring–return, tip–send. The rated level for both connectors is +4 dB.
AD Input inserts can be turned on and off individually by using the INSERT
ON/OFF switches, so you don’t have to disconnect your external equipment in
order to remove an insert.
Stereo Out
See page 92 for information on the Stereo Out outputs.
Control Room Monitor Out
See page 136 for information on the Control Room Monitor output.
Studio Monitor Out
See page 137 for information on the Studio Monitor output.
Omni Outs
The 02R96 features assignable Omni Outs on balanced 1/4-inch TRS phone jacks. Omni
Outs can be patched to Bus Outs, Aux Sends, the Stereo Out, Input or Output Channel
Insert Outs, or Surround Monitor Channels (see page 69). In addition, Input Channel
Direct Outs can be patched to the Omni Outs (see page 70).
The maximum output level of each OMNI OUT can be set internally to either +4 dB
(–10 dB operating level) or +18 dB (+4 dB operating level). Contact your dealer for further
details.
2TR Analog INs
The 02R96 features two sets of 2-track analog inputs: 2TR IN ANALOG 1
+4 dB (BAL) uses balanced 1/4-inch TRS phone jacks. 2TR IN ANALOG 2
–10 dBV (UNBAL) uses unbalanced phono connectors. These inputs can be
monitored via the Control Room monitors by pressing the CONTROL
ROOM [2TR A1] and [2TR A2] buttons. They can be patched to Input
Channels (see page 66), Input Channel Insert Ins (see page 67), or Output
Channel Insert Ins (see page 69).
OFF
ON
INSERT