Owner`s manual

Sending Bus Outs to the Stereo Out 97
02R96 Version 2—Owner’s Manual
Sending Bus Outs to the Stereo Out
Bus Outs can be routed to the Stereo Out buses as follows. Bus Out to Stereo Out settings
can be stored in the Bus to Stereo library, which contains 1 preset memory and 32 user
memories. See “Bus to Stereo Library” on page 147 for more information.
1 Use the SELECTED CHANNEL ROUTING [DISPLAY] button to locate the Bus
to Stereo page.
2 Use the cursor buttons to select the parameters, and use the Parameter
wheel, INC/DEC buttons, and [ENTER] button to set them.
PAN: These controls are used to pan the Bus Out signals between the left and right Stereo
Out buses. The currently selected Pan control can be set to center by pressing [ENTER].
ON/OFF: These buttons are used to turn on and off the Bus Out to Stereo Out routing.
Faders: These faders are used to set the Bus Out to Stereo Out levels. Fader knobs appear
highlighted when faders are set to 0.0 dB.
Press the [ENTER] button to set the currently-selected fader to 0.0 dB. You can copy the
currently-selected fader position to other faders by double-clicking the [ENTER] button.
Viewing Bus Out Settings
Parameter and fader settings for each Bus Out can be viewed and set on the View pages. See
“Viewing Channel Parameter Settings” on page 129 and “Viewing Channel Fader Settings”
on page 130 for more information.
Naming Bus Outs
Bus Outs can be named for easy identification. See “Naming Channels” on page 134 for
more information.