Supplementary Manual

2 Use the cursor buttons to select the parameters, and use the Parameter wheel,

INC/DEC buttons, and [ENTER] button to set them.

SPEAKER SETUP:

These parameters are for setting the volume balance of the surround mon-

itor speakers. Select the OSC (Oscillator) parameter and choose from PINK NOISE, 500-2K

(pink noise through a 500 Hz to 2 kHz BPF), 1K (1 kHz sinewave), or 50 Hz (50 Hz sinewave).

Use the ON/OFF button to turn the Oscillator on and off. When on, the Oscillator outputs a

signal at –20 dB to the Surround Channels whose icons are highlighted. You can turn on and

off Oscillator output for speakers individually. Speaker icons can be selected by using the cursor

buttons. The signal phase of the LFE Channel can be reversed by using the SW phase button.

When ROTATE is on, the Oscillator signal is output by each speaker in turn in a clockwise

direction (3 second signal, 2 second pause).

SURR. MODE:

This indicates the currently selected Surround mode, which is set on the Sur-

round Mode page (see page 85).

MONITOR MATRIX:

This is used to select the Surround Monitor Matrix. In 6.1 Surround

mode, you can select 6.1, 5.1, 3-1, or ST. In 5.1 Surround mode, you can select 5.1, 3-1, or ST.

In 3-1 Surround mode, you can select 3-1 or ST.

When a down mix Monitor Matrix is selected, you can attenuate signals by using the ATT

parameters.

You can use the Surround Monitor settings in Stereo mode, but Monitor Matrix is ﬁxed to ST.

The following screen shows an example in 6.1 Surround mode and 3-1 Monitor Matrix mode.

Note:

If you had been monitoring with the surround mode set to 6.1 and the monitor matrix mode

set to 6.1 on 02R96 units with system software earlier than V2.1, the playback may not always be

correct on V2.1.

Note:

If you choose monitor matrix mode = 3-1, you must set the following three attenuation

amounts to the same value.

• ATT1 for surround mode 3-1

• ATT4 for surround mode 5.1

• ATT5 for surround mode 6.1

These ATT values are not attenuators for down-mixing; rather, they are used as monitor adjust-

ment attenuators for lowering the playback volume of the Ls, Rs, Ls2, and Rs2 speakers.