Owner's Manual

Using Inserts 115
02R96 Version 2—Owner’s Manual
Using Inserts
Input Channels, Bus Outs, Aux Sends, and the Stereo Out all feature assignable Inserts.
1 Use the SELECTED CHANNEL DISPLAY ACCESS [PHASE/INSERT] button to
select the Insert page.
The Insert page for Input Channels is shown below.
The Insert page for Bus Outs, Aux Sends, and the Stereo out is shown below.
2 Use the LAYER buttons to select Layers, and use the [SEL] buttons to select
channels.
3 Use the cursor buttons to select the parameters, and use the Parameter
wheel, INC/DEC buttons, and [ENTER] button to set them.
POSITION: This determines the position of the Insert and Compressor within the chan-
nel, and can be set to pre-EQ, pre-fader, or post-fader. Click the desired [COMP] and
[INSERT] buttons in the POSITION block diagram to select the Compressor and Insert
positions.
INSERT ON/OFF: This turns the currently selected channel’s Insert on and off.
INSERT OUT: This selects the destination for the Insert Out, which can be a Slot Output,
Omni Out, 2TR Digital Output, or the input to an internal effects processor. See page 241
and page 245 for Input and Output patch parameter lists. The Port ID of the currently
selected destination is displayed below the currently selected channel’s Long name in the
upper-right corner of the page. The destination port can also be selected by using the Patch
Select window (see page 71), which is accessed by pressing [ENTER] while this parameter
is selected. Insert Outs can also be patched on the Output Patch pages. See “Output Patch-
ing” on page 68 for more information.