Owner's Manual

Output Channel Mute Master 129

02R96 Version 2—Owner’s Manual

Output Channel Mute Master

The 02R96 features a Mute Group Master function that enables you to mute all channels in

the Mute group using the MASTER button, much like a Mute group on an analog mixing

console. When this function is enabled, the channel [ON] buttons do not control the chan-

nels in the group collectively.

1 Follow Steps 1–4 described in the “Grouping Output Channel Mutes

(ON/OFF)” section on the previous page, select the Output Mute Master

check box, then press the [ENTER] button to check or uncheck the Output

Mute Master check box.

When the Output Mute Master check box is checked, the MASTER MUTE but-

ton in each group mutes or unmutes the channels in the corresponding group.

If the channels are muted by the Mute Master function, the corresponding channel [ON]

button indicators ﬂash. You can assign the MASTER MUTE button function to one of the

USER DEFINED KEYS for convenient operation.

Viewing Channel Parameter Settings

The parameter setting of the currently selected Input Channel, Bus Out, Aux Send, or the

Stereo Out can be viewed and set on the Parameter View pages.

1 Use the DISPLAY ACCESS [VIEW] button to select the Parameter View page.

2 Use the LAYER buttons to select Layers, and use the [SEL] buttons to select

channels.

3 Use the cursor buttons to select the parameters, and use the Parameter

wheel, INC/DEC buttons, and [ENTER] buttons to set them.

Input Channels

This is the Parameter View page for the Input Channels.

GATE: The following Gate parameters for the currently selected Input Channel can be set:

Gate On/Off, Threshold, Range, Attack, Decay, and Hold. The GR meter indicates the

amount of gain reduction being applied by the Gate. Also displayed are the gate curve and

gate type. See “Gating Input Channels” on page 74 for more information.

COMP: The following Compressor parameters for the currently selected channel can be

set: Comp On/Off, Threshold, Ratio, Attack, Release, Gain, and Knee. The GR meter indi-

cates the amount of gain reduction being applied by the Compressor. Also displayed are the

comp curve and comp type. See “Compressing Channels” on page 116 for more informa-

tion.

INSERT: The currently selected channel’s Insert can be turned on and off and patched. See

“Using Inserts” on page 115 for more information.