Owner's Manual

Punching In & Out Individual Parameters 183
02R96 Version 2—Owner’s Manual
Punching In & Out Individual Parameters
During Automix rerecording, channels can be punched in and out by pressing the channel
strip [AUTO] buttons. Individual parameters can be punched in and out as follows.
If during Automix recording you punch in an individual parameter by using the controls
listed in the above table, even if some OVERWRITE buttons are on, only the existing data
of that particular parameter will be overwritten. Likewise, when you punch out an individ-
ual parameter by using the controls listed above, only that particular parameter will be
punched out.
If during Automix recording you press an [AUTO] button to punch in a channel, the exist-
ing data of all parameters for which the corresponding OVERWRITE buttons are on will be
overwritten. When you press the [AUTO] button to punch out of recording, all of those
parameters will be punched out.
Parameter Channel
OVER-
WRITE
Operation Punch In Punch Out
Channel Levels
(faders)
Input
FADER
Set Layer to input, Fader mode to
Fader
Touch fader knob
and adjust
1
1. TOUCH SENSE on Fader Edit page must be TOUCH or LATCH.
Release fader
knob
2
2. TOUCH SENSE on Fader Edit page must be TOUCH.
Bus Out, Aux
Send
Set Layer to Master, Fader mode
to fader
Stereo Out Stereo Out fader
Group Master
faders
Set the Fader mode to Fader; Set
the Group Master in the User
Assignable Layer.
Pan
Input PAN
Set Layer to input, Encoder mode
to Pan.
Press Encoder
and adjust
Press Encoder
Surround Pan
Input SURR
Select Input Layer and assign Sur-
round LFE Level or Surround Pan
Wheel to the Encoders
Press Encoder
and adjust
Press Encoder
EQ (F, Q, G)
All channels EQ
Turn on Auto EQ Edit In prefer-
ence (see page 233). Use
SELECTED CHANNEL EQUALIZER
section (If EQ parameter assigned
to an Encoder, also use Encoders)
Adjust control
Press [AUTO] but-
ton
EQ On/Off
Press EQ [ON]
button
Press [AUTO] but-
ton
Aux send 1–8 levels
Input AUX
Set Layer to input, Fader mode to
Aux
Touch fader knob
and adjust
1
Release fader
knob
2
Set Layer to input, Encoder mode
to Aux
Press Encoder
and adjust
Press Encoder
Effect parameters
(certain parameters)
Effects proces-
sors 1–4
— Select internal effects processors
Push Parameter
1–4 control, or
select the param-
eters on the Effect
Edit page, then
press [ENTER]
Push Parameter
1–4 control, or
select the param-
eters on the Effect
Edit page, then
press [ENTER]
User Defined Plug-Ins
(parameters 1–4)
Plug-Ins 1–4 — Select Plug-Ins
Push Parameter
1–4 control.
Select the desired
parameter on the
Plug-in Edit page,
then press
[ENTER]
Push Parameter
1–4 control Select
the desired
parameter on the
Plug-in Edit page,
then press
[ENTER]
User Defined Remote
Layers
Faders FADER Select User Defined Remote Layer
Touch fader knob
and adjust
1
Release fader
knob
2
Encoders PAN Select User Defined Remote Layer
Press Encoder
and adjust
Press Encoder