Owner's Manual

196 Chapter 18—Pro Tools Remote Layer
02R96 Version 2—Owner’s Manual
18 Pro Tools Remote Layer
The 02R96 features a Remote Layer target especially designed for controlling Pro Tools.
If an optional MB02R96 Peak Meter Bridge is installed, Pro Tools channel levels are dis-
played on its meters.
Configuring Windows Computers
1 Connect your PC.
The 02R96 can be connected to your Windows PC by connecting the TO HOST SERIAL
port to a suitable RS232 serial port on your PC, or by connecting the TO HOST USB port
to a USB port on your PC. If you use the TO HOST SERIAL port, make sure that the TO
HOST SERIAL parameter on the MIDI/TO HOST Setup page is set to PC-2 (see page 191).
2 Install the necessary drivers.
Once your PC is connected, you’ll need to install the TO HOST SERIAL or TO HOST USB
drivers included on the 02R96 CD-ROM.
Configuring Macintosh Computers (MacOS 8.6 to 9.2.2)
1 Connect your Mac.
The 02R96 can be connected to your Mac by connecting the TO HOST SERIAL port to
either the Printer or Modem port on your Mac, or by connecting the TO HOST USB port
to a USB port on your Mac. If you use the TO HOST SERIAL port, make sure that the TO
HOST SERIAL parameter on the MIDI/TO HOST Setup page is set to Mac (see page 191).
2 Install OMS.
The 02R96 communicates with Pro Tools via OMS (Open Music System) software. If you
already have OMS installed on your Mac, there’s no need to install it again and you can
move on to the next section. If you don’t already have OMS installed, it’s included on the
02R96 CD-ROM. Refer to the OMS documentation included on the 02R96 CD-ROM for
more information on installing.
3 Install Yamaha USB MIDI driver 1.04 or later.
If you are using the TO HOST USB port, you must also install the Yamaha USB MIDI driver
included on the 02R96 CD-ROM. See the included documentation for more information.
Configuring Macintosh Computer (MacOS X)
1 Connect the 02R96 TO HOST USB port to a USB port on your Mac.
2 Install the Yamaha USB MIDI Driver for MacOS X on the computer.