Owner's Manual

30 Chapter 2—Control Surface & Rear Panel
02R96 Version 2—Owner’s Manual
LAYER
A
1–24 & 25–48 buttons
These buttons select the Input Channel Layers, which determine which Input Channels are
controlled by the channel strips. The LAYER button indicator for the currently selected
Layer lights up. See “Selecting Layers” on page 47 for more information.
B REMOTE button
This button selects the Remote Layer, which can be used to control external devices, includ-
ing DAWs. See “About the Remote Layer” on page 219 for more information. Its button
indicator lights up when the Remote Layer is selected. See “Selecting Layers” on page 47 for
more information.
C MASTER button
This button selects the Master Layer, from which the channel strips control Input Channels
49–56, Bus Outs, and Aux Sends. Its indicator lights up when the Master Layer is selected.
See “Selecting Layers” on page 47 for more information.
STEREO
A
AUTO button
This button is used exclusively to set Automix recording and playback for the Ste-
reo Out. Its indicator lights up orange in Record-Ready mode, red while record-
ing, and green during playback. See “Channel Strip [AUTO] Buttons” on page 174
for more information.
B SEL button
The Stereo Out [SEL] button is used exclusively to select the Stereo Out for editing
with the SELECTED CHANNEL section. Its indicator lights up when the Stereo
Out is selected. Each time it’s pressed, the selection toggles between the Stereo
Out’s left and right channels. See “Selecting Channels” on page 48 for more infor-
mation. It can also be used to add and remove the Stereo Out to and from EQ,
Comp, Fader, and Mute groups.
C ON button
This button is used exclusively to mute the Stereo Out. Its indicator lights up when
the Stereo Out is on. See “Muting the Stereo Out (ON/OFF)” on page 93 for more
information.
D Fader
This 100 mm touch-sensitive motorized fader is used exclusively to adjust the level
of the Stereo Out. See “Setting the Stereo Out Level” on page 93 for more infor-
mation. It can be grouped with other Output Channel faders for simultaneous
operation. See “Grouping Output Channel Faders” on page 126 for more infor-
mation. It can also be used to select the Stereo Out, see “Auto Channel Select &
Touch Sense Select” on page 49, or to punch the Stereo Out in and out during
Automix recording. See “Punching In & Out Individual Parameters” on page 183
for more information.
MASTER25 48
REMOTE1 24
LAYER
2
3
1
ON
SEL
AUTO
70
60
50
40
30
20
15
10
5
0
STEREO
STEREO
3
2
1
4