Owner's Manual

Selecting Fader Modes 49
02R96 Version 2—Owner’s Manual
Auto Channel Select & Touch Sense Select
While the Auto Channel Select preference is on (see page 230), channels can be selected by
moving the corresponding fader or Encoder, or by turning on the corresponding [AUTO],
[SOLO], or [ON] button. Note that you can use the [AUTO] buttons to select channels only
during Automix recording or in Automix record ready mode.
While the Fader Touch Sense SELECT preference is on (see page 232), channels can be
selected simply by touching the fader knobs.
Selecting Fader Modes
The exact function of each fader depends on the selected Layer and Fader mode.
1 Select a Layer, as explained on page 47.
2 Use the FADER MODE buttons to select a Fader mode.
[FADER]: Channel faders control Input Channel levels or Output Channel master levels,
depending on the selected Layer.
[AUX]: Channel faders control Aux Send levels, depending on the selected Layer.
The indicator of the currently selected FADER MODE button lights up.
The following table shows the channel fader functions for each Layer and Fader mode.
Layer
Fader
Mode
Fader
1–8 9–16 17–24
1–24
Fader Input Channels 1–24 level
Aux Input Channels 1–24 Aux Send level
25–48
Fader Input Channels 25–48 level
Aux Input Channels 25–48 Aux Send level
Master
Fader
Input Channels 49–56
level
Aux Sends 1–8 master
level
Bus Outs 1–8 master
level
Aux
Input Channels 49–56
Aux Send level
No operation: faders fixed at –∞
Remote
Fader
Operation depends on the selected target.
See “About the Remote Layer” on page 219 for more information.
Aux
AUXFADER
FADER MODE