Owner's Manual

50 Chapter 3—Operating Basics
02R96 Version 2—Owner’s Manual
Selecting Encoder Modes
The exact function of each Encoder depends on the selected Layer and Encoder
mode. There are two preset Encoder modes, Pan and Aux, and two assignable
modes, for which you can choose from over 40 parameters.
1 Select a Layer, as explained in page 47.
2 Use the ENCODER MODE buttons to select an Encoder mode.
[PAN]: Encoders function as Pan controls.
[AUX]: Encoders control Aux Send levels, depending on the selected Layer.
[ASSIGN 1/2]: Encoders control the parameters assigned to the ASSIGN buttons. See
“A ssigning Parameters to the ENCODER MODE Assign Buttons” on page 51 for more
information.
The indicator of the currently selected ENCODER MODE button lights up.
The following table shows the exact Encoder functions for each Layer and Encoder mode.
Layer
Encoder
Mode
Encoder
1–8 9–16 17–24
1–24
Pan Input Channels 1–24 pan
Aux Input Channels 1–24 Aux Send level
Assign 1/2
Input Channels 1–24 assigned parameter
1
1. When Alt Layer is assigned, the Encoders enable you to control a parameter that is assigned to the cor-
responding channel fader in the partner layer. (A partner layer would be the layer of channels 25-48
if the layer of channels 1-24 is currently selected.)
25–48
Pan Input Channels 25–48 pan
Aux Input Channels 25–48 Aux Send level
Assign 1/2
Input Channels 25–48 assigned parameter
1
Master
Pan
Input Channels 49–56
pan
No operation
Aux
Input Channels 49–56
Aux Send level
No operation
Assign 1/2
Input Channels 49–56
assigned parameter
Aux Sends 1–8
assigned parameter
Bus Outs 1–8 assigned
parameter
Remote
Pan
Operation depends on the selected target.
See “About the Remote Layer” on page 219 for more information.
Aux
Assign 1/2
AUXPAN
ASSIGN 2ASSIGN 1
ENCODER MODE
DISPLAY