User Manual

2
Installing REV-X
See the Add-On Effects Installation Guide for more information on installing REV-X.
Using REV-X
As with other effects, you can recall and edit the REV-X programs on the console or Studio Manager. The basic
operation is as follows:
1
Select one of the internal effects processors.
2
Patch the signal to and from the currently selected effects processor.
3
Locate the Effects Library page.
4
Select REV-X Hall, REV-X Room or REV-X Plate.
5
Recall the selected effect.
6
Locate the Effects Edit page.
7 Set the parameters. (See the “Part Names and Functions” section for more information on REV-X
parameters.)
The procedure for recalling and editing REV-X varies depending on the console you are using.
Refer to the Owner’s Manual that came with your console for more information.
Editing Parameters in Studio Manager
In Studio Manager, editable parameters appear in both the REV-X window and the Generic Editor window.
Basically, the REV-X window enables you to edit REV-X specific parameters, and the Generic Editor window
enables you to edit parameters common to the REV-X and other Effects.
Refer to the Studio Manager Owner’s Manual for your console for more information regarding the Generic
Editor window.
Studio Manager Generic Editor Window