Operation Manual

104 Chapter 10—Aux Sends

02R96 Version 2—Owner’s Manual

Excluding Certain Channels from Aux Sends (Mix Minus)

You can quickly exclude certain channel signals from Aux Sends by using the controls on

the top panel. This operation is called “Mix Minus.”

For example, when Aux Sends are being used as monitors for the musicians or a narrator,

you can turn off the audio signals of the musicians or narrator, excluding them from the

monitor sound.

1 Press and hold down the AUX SELECT [AUX 1]–[AUX 8] buttons of the desired

Aux Sends.

The [ON] button indicators in the channel strip remain lit while you hold down the button.

This means that signals routed from channels with a lit [ON] button indicator to the Aux

Send are turned on.

2 Press the [ON] buttons of the Input Channels you wish to exclude from the

Aux Send. You can select multiple channels.

The selected channels’ [ON] button indicators turn off, and signals routed from those

channels to the corresponding Aux Send are turned off. “MIX MINUS FOR AUX * ”

appears at the bottom of the screen. (The asterisk represents an Aux number.)

3 To reset the setting, while pressing and holding down the AUX SELECT

[AUX 1]–[AUX 8] buttons you pressed in Step 1, press the [ON] buttons you

pressed in Step 2.

The corresponding [ON] button indicators light up.

Copying Channel Fader Positions to Aux Sends

While Aux Sends are in Variable mode, you can copy all Input Channel fader positions on

one layer to the corresponding Aux Sends.

This is convenient when you wish to send to the musicians monitor signals that have the

same balance setting as the Stereo Out signals.

1 Locate the copy source layer button from the Input Channel Layer buttons,

then press and hold down the button.

2 Press one of the AUX SELECT [AUX 1]–[AUX 8] buttons to select the desired

Aux Send copy destination.

The conﬁrmation message appears.

Note: If you release the AUX SELECT button before you proceed to Step 2, you will be unable

to complete the Mix Minus operation.

Tip: At this time, the Send Level controls on the Aux Send page are grayed out.

Note: If you release the button in the LAYER section before you proceed to Step 2, you will be

unable to complete the Copy operation.