Operation Manual

180 Chapter 16—Automix
02R96 Version 2—Owner’s Manual
Inserting Mix Parameters into Automix
You can insert the static mix parameter settings into the range specified by the IN and OUT
parameters in the current Automix data. This is useful when you want to quickly insert
static EQ settings into a specified range of the Automix data.
1 Follow Steps 1–4 as described in the “Recording an Automix” section on the
previous page, then press the DISPLAY ACCESS [AUTOMIX] button to display
the Automix Main page.
2 Use the cursor buttons to select the INSERT button, then press [ENTER].
A confirmation message appears.
3 Use the IN and OUT parameters to specify the region to be inserted.
The default IN and OUT parameter values use the Locate memories specified by the Insert
Time Link preference (see page 234). If you change the Locate points for the corresponding
Locate memories while the confirmation message is displayed, the IN and OUT parameter
values will be updated accordingly.
If MIDI clock is selected as a timecode source, these parameters indicate the position in
bar:beats:clocks and use the IN and OUT parameter values in the TIME SETTING section
on the Event Job page. In this case, the Insert Time Link preference is disabled.
Time Time
IN OUT
Before Insert After Insert
Event No event Event
Event erased
Value prior to Insert
Inserted
parameter value