Operation Manual

Group Master for Input Channel Faders 81
02R96 Version 2—Owner’s Manual
You can also make these settings in the Input Fader Group Master page, as shown below.
3 Use the DISPLAY ACCESS [GROUP] button to locate the Input Fader Group
Master page.
4 Use the cursor buttons to select parameters, then use the Parameter wheel,
INC/DEC buttons, or [ENTER] button to set the parameters.
INPUT FADER MASTER: When this check box is checked, you can set the master levels
for the Input Fader groups. The resultant Input Channel level equals the corresponding
Input Channel fader level plus the Group Master level.
ALL NOMINAL: This button resets the master levels for all Input Fader groups to nomi-
nal.
ON/OFF: This turns each Input Fader group on or off. This function works like a VCA
mute on an analog mixing console.
Faders: These faders adjust the master levels of the Fader groups. Fader knobs are high-
lighted when faders are set to 0.0 dB. Press the [ENTER] button to set the currently-selected
fader to 0.0 dB.
You can also control the parameters from the channel strips on the control surface as
described below by using the User Assignable Layer of the Remote Layers. See page 228 for
information on the User Assignable Layer.
Encoders: The Encoders are not available.
[AUTO] buttons: These buttons are used to control the Fader Group Master On/Off and
the master level during Automix.
[SEL] buttons: These buttons move the cursor on the Input Fader Group Master page.
[SOLO] buttons: These buttons turn the Solo function of each Fader group on and off.
You can monitor all the channels in each Fader group.
Channel Faders: The channel faders enable you to set the master level for each Fader
group.