YVC-1000MS User Manual

YVC-1000MS User's Manual

This section describes how to connect each communication device.

After connecting them, check whether or not sounds are output normally.

■ Before connecting, check the following.

Prepare the USB cable supplied with the product.

The following system environment is required in the PC to be connected to the product.

• OS: Windows (*1)

• USB: USB 2.0 or later

(*1) For the supported versions, refer to the following website:

http://www.yamaha.com/products/en/communication/

• It is not possible to connect and use more than one microphone or speaker including the product to one PC at the

same time.

• Do not use a cable other than the USB cable supplied with the product. If a different USB cable is used, it may

cause operational problems.

• The product must be connected directly to a PC. If the product is connected to a PC via a USB hub, it may cause

operational problems.

• In rare cases, the audio playback may be interrupted due to PC conditions such as the workload or limited free

space in memory.

■ Connection

Connect the product to a PC using the supplied USB cable.

Before connecting them, set the product to the standby mode.

You do not need to install the USB driver separately because the product is recognized as a basic USB audio device by the PC.

Connecting to communication equipment

Connecting to a PC using the USB cable

Notes

To USB port

Plug into an

outlet

Connect to the

microphone